Panasonic WJ-NT314 Configure the settings relating to the NTP server NTP, Time zone, NTP port

Configure the settings relating to the NTP server [NTP]

Click the [NTP] tab on the "Basic setup" page. (☞ page 20)

The settings relating to the NTP server such as the NTP server address, port number, etc. can be configured on this page.

[Time zone]

Select a time zone according to the location where the unit is in use.

Default setting: (GMT) Greenwich Mean Time: Dublin, Edinburgh, Lisbon, London

[Time adjustment]

Select the time adjustment method from the following. Manual setup: Time set on the [Basic] tab on the

"Basic setup" page will be used as the standard time of the unit.

Synchronization with NTP server: Time automatically adjusted by synchronizing with NTP server will be used as the standard time of the unit.

Default setting: Manual setup

[NTP server address]

Enter the IP address or the host name of the NTP serv- er.

Number of characters that can be entered: 1 - 128

characters

Default setting: (blank)

Important:

When entering the host name for "NTP server address", it is necessary to configure the DNS set- tings on the [Network] tab of the "Network setup" page. (☞ page 51)

[NTP port]

Enter a port number to be used for the NTP server.

Available port number: 1 - 65535

Default setting: 123

[Synchronization interval]

Select an interval (1 - 24 hours: in 1 hour intervals) of synchronization with the NTP server.

Default setting: 1 hour

22