Panasonic WJ-NT314 manual Configure the settings relating to SNMP SNMP, Community name, Unit title

Configure the settings relating to SNMP [SNMP]

Click the [SNMP] tab on the "Network setup" page. (☞ page 50)

The settings relating to SNMP can be configured on this page. It is possible to check the status of the unit by con- necting to the SNMP manager. When using the SNMP function, contact the network administrator.

[Community name]

Enter the community name to be monitored. Number of characters that can be entered: 0 - 32

characters

Default setting: (blank)

Important:

When using the SNMP function, it is necessary to enter the community name. When no community name is entered, the SNMP function will not work.

[Unit title]

Enter a unit title to be used to manage the unit with the SNMP function.

Number of characters that can be entered: 0 - 32

characters

Default setting: (blank)

[Unit location]

Enter the name of the location where the unit is installed.

Number of characters that can be entered: 0 - 32

characters

Default setting: (blank)

[Contact (Destination address or phone number of manager)]

Enter the mail address or the phone number of the SNMP manager.

Number of characters that can be entered: 0 - 255

characters

Default setting: (blank)

Notes:

•"" is regarded as a blank.

•It may take around 30 seconds until the setting is applied.

54