Configure the settings of the servers [Server setup]
The settings relating to the mail server and the FTP server can be configured on this page. The "Server setup" page has 2 tabs of the [Mail] tab and the [FTP] tab.
Configure the settings relating to the mail server [Mail]
Click the [Mail] tab on the "Server setup" page.
The settings relating to the mail server used to send the alarm mail can be configured on this page.
[SMTP server address]*
Enter the IP address or the host name of the SMTP server used to send
Number of characters that can be entered: 1 - 128
characters
Default setting: (blank)
[POP server address]*
When "POP before SMTP" is selected for "Authentication", enter the IP address or the host name of the POP server.
Number of characters that can be entered: 1 - 128
characters
Default setting: (blank)
Important:
When entering the host name for "NTP server address", it is necessary to configure the DNS set- tings on the [Network] tab of the "Network setup" page. (☞ page 51)
[Authentication]
Select the authentication method to send
None: It is not necessary to clear any authentication to send
POP before SMTP: It is necessary to clear the POP server authentication first to use the SMTP server to send
SMTP: It is necessary to clear the SMTP server authen- tication to send
Default setting: None
Note:
When you don’t know the authentication method to send
[User name]
Enter the user name to access the server.
Number of characters that can be entered: 1 - 32
characters
Default setting: (blank)
[Password]
Enter the password to access the server.
Number of characters that can be entered: 0 - 32
characters
Default setting: (blank)
[Sender mail address]
Enter the mail address of a sender.
Entered mail address will be displayed in the "From" (sender) line of the sent mails.
Number of characters that can be entered: 3 - 128
characters
Default setting: Blank
48
