Configure the settings relating to Panasonic alarm protocol [Panasonic alarm protocol]
Click the [Notification] tab on the "Alarm setup" page. (☞ page 40)
The settings relating to Panasonic alarm protocol can be configured on this page.
■Panasonic alarm protocol setup
[Panasonic alarm protocol]
Select "ON" or "OFF" to determine whether or not to notify of an alarm occurrence by Panasonic alarm proto- col when an alarm is detected.
Default setting: OFF
Note:
When "ON" is selected, the alarm occurrence will be notified to the registered destination IP addresses in order (to IP address 1 first, to IP address 8 last).
[Destination port]
Select a destination port of the Panasonic alarm proto- col from the following.
Available value: 1 - 65535
Default setting: 1818
[Retry times]
Select a retry time of Panasonic alarm protocol. Available value: 1 to 30
Default setting: 2
■Panasonic alarm protocol
[IP address 1] to [IP address 8]
Enter the destination IP address of the Panasonic alarm protocol from the following. Host name is unavailable for the IP address. Up to 8 destination addresses can be registered.
Default setting: (blank)
<Unavailable IP addresses>
0.*.*.* *.*.*.0
255.*.*.* *.*.*.255 127.0.0.1
Class D address (224.0.0.0 - 239.255.255.255) Class E address (240.0.0.0 - 255.255.255.255)
To provide notification at an alarm occurrence to the desired IP address using Panasonic alarm protocol, check the "Alarm" checkbox respective to the desired IP address.
To provide notification using Panasonic alarm protocol when any of the following has occurred, check the "Diag." checkbox respective to the desired address.
•When notification of the remaining space of the SD memory card has been provided (☞ page 23)
•When the SD memory card has become full
•When mounting of the SD memory card has failed
To delete the registered address, click the [DEL] button respective to the desired address.
Important:
•Confirm that the destination IP addresses are regis- tered correctly. When a registered IP address does not exist, notification may be delayed.
•Depending on the status of this unit or network, noti- fication may be delayed. When activating event recording, it is recommended to set
45
