COMSPHERE 3550 Series Data Service Units

 

 

Table C-1

 

 

DSU Status Indicators

Label

Color

Description

 

 

 

OK

Green

Health and status indicator: DSU operation is normal. (The DSU has not

 

 

detected any of the faults listed under Alrm, below.)

 

 

This indicator flashes two times per second if a message from the NMS is

 

 

present.

 

 

 

Alrm

Red

Health and status indicator:

 

 

There is a fault in the local or remote DSU, DBM, or DDS facility, or there is a

 

 

corrupted configuration.

 

 

The following alarms at the local or remote DSU cause the Alrm status

 

 

indicator on the affected DSU to light:

 

 

Configuration Corrupt

 

 

Device Fault

 

 

Dial Tone Test Failure

 

 

DTR Alarm

 

 

Facility Alarm

 

 

MUX Failure

 

 

No Response

 

 

Redundant Power Alarm

 

 

Streaming Terminal

 

 

Subnetwork Alarm

 

 

Out-of-Frame Threshold

 

 

Out-of-Service

Test

Yellow

Active device (DSU or DBM) is either performing a test or other DSUs or DBMs

 

 

are in Test mode.1

Dial

Yellow

DBM is active

 

 

Rapid flashing: Call setup in progress

 

 

Slow flashing: Call established but in Standby mode

 

 

Steady ON: Backup call established and active

 

 

 

TXD, RXD, RTS,

Green

Internal lead states at the DSU/DTE interface(circuit designations):

CTS, DSR, DTR,

 

Control circuit active or

LSD

 

 

Data circuit SPACE(ing).

 

 

 

 

 

Front Panel

Yellow

DSU is currently selected at the SDCP. (The SDCP addresses one DSU at a

(Model 3551 only)

 

time.)

 

 

 

1 The DSU or DBM is automatically put into Test mode when a remote DSU or DBM is performing a disruptive test (e.g., a Local Loopback (LL) at the control DSU. A DSU or DBM in Test mode has its DTE interface turned Off).

 

 

Table C-2

 

 

SDCP Status Indicators

Label

Color

Description

 

 

 

OK

Green

Health and status indicator for the selected DSU; mirrors the OK indicator on

 

 

the DSU faceplate.

 

 

 

Alrm

Red

Health and status indicator for the selected DSU; mirrors the Alrm indicator on

 

 

the DSU faceplate.

 

 

 

BckUp

Yellow

Mirrors the BckUp LED on the selected DSU.

 

 

 

Test

Yellow

Mirrors the Test indicator on the selected DSU.

 

 

 

EC

Green

Error Correction indicator is for future use by dial network modems.

 

 

 

C-2

December 1996

3550-A2-GB20-20

Page 106
Image 106
Paradyne 3551 manual Table C-1, DSU Status Indicators, Label Color Description, Table C-2, Sdcp Status Indicators