COMSPHERE 3550 Series Data Service Units
Once loaded, the following Edit/Save submenu appears:
Edit / Save:
SAVE DSU DBM
F1 F2 F3
Press the 
or 
key to scroll the following configuration option sets into view: DSU, Diagnostic (DSU, DBM, External DBU, and General), DBM, External DBU, General, Backup, MUX (Copy, Setup, and Ports), and Port Speed (DSU, DBM, and External DBU).
If your unit has a DBM installed, the External DBU option sets will not appear. If your unit does not have a DBM installed, the DBM option sets will not appear. The Backup option set only appears when a DBM is installed or an external DBU is configured to originate backup; otherwise, the Backup option set will not appear. If the unit does not have a TDM/Flex installed, the MUX and Port Speed option sets will not appear.
Using the DCP to
Set Configuration Options
Configuration options can be edited and saved to either the Activ or Usr1 areas. This section provides guidelines for using the DSU's diagnostic control panel (DCP) to perform these operations.
In addition, an example is included to illustrate DCP operation.
Editing Configuration Values
To edit or change configuration options:
.Procedure
1.Select Local, or Remot (Remote) and the remote DSU's network address.
2.Select Confg (Configuration branch).
Press the 
key key until Confg appears, then press the function key (F1, F2, or F3) directly below Confg.
3.Select Opts (Configuration Options).
4.Select storage area (Activ, Remt, Usr1, etc.) from the Load from screen.
If the unit is a control and you select Remt, enter the network address of the remote DSU.
5.Select the option set (e.g., DSU, Diag, DBM) to be edited.
The first configuration option within that set appears. Page through each configuration option within the set as follows:
a.Press the F1 key to go to the Next configuration option. These configuration options scroll or wrap around (e.g. first, then last; or last, then first).
b.To return to the previous configuration option,
press the 
key instead of selecting Next. Prev appears over the F1 key.
c.Select Prev by pressing the F1 key.
As you edit configuration options, be aware of the following:
•The first line of each configuration option identifies the option and its current setting.
If configuration data has been corrupted, ??? will appear in place of the current value. If this occurs, reset all configuration options, along with the network address. If a DBM is installed, check the Backup Directory entries, the poll list, and the DSU's local telephone number as well.
•The second line displays all values that are available for selection ± three at a time, one above each function key.
ÐPress the 
or 
key to scroll other selections into view.
ÐPress the function key (F1, F2, or F3) directly below a value to select it.
ÐSelect Next to proceed to the next option.
ÐSelect Prev to return to a previous option.
ÐPress the 
key to return to the Edit/Save submenu or screen, and select the next option set to be edited.
December 1996 |
