Installing the Model 3551 DSU 3

Overview

3-1

Before You Begin

3-2

How to Change Hardware Straps

3-2

Installing the DSU

3-5

Power-Up Routine

3-8

Connecting to the Network

3-8

Connecting to the NMS

3-8

Connecting to the Dial (or PSTN) Network

3-8

Connecting to the DDS (or LADS) Network

3-9

Connecting the DSU to a DTE

3-9

Addressing the Unit

3-9

Tributary DSU Addressing

3-10

Verifying Operation and Testing Connections

3-10

To Connect the SDCP to a DSU

3-11

Verifying Network Addresses, the Network, and DBM Operation

3-11

Other Tests

3-12

Overview

A Model 3551 DSU is designed for installation in a COMSPHERE 3000 Series Carrier, which supplies power and provides the interfaces for connecting to the DDS or dial networks. Up to 16 DSUs can be installed in the carrier. Refer to the COMSPHERE 3000 Series Carrier, Installation Manual for additional carrier and installation information.

The DSU is delivered ready to install in the carrier. It is configured as a control DSU for operation at 9.6 kbps on a multipoint circuit.

A rear connector plate, which is installed onto the rear of the carrier, is shipped with the DSU. The rear connector plate contains two connectors: a 25-pin EIA-232-D/V.24 connector and a 25-pin V.35 connector. Once installed, the DSU can be removed from the front of the carrier without disconnecting the DTE cables.

Installation of the DSUs and carrier-related equipment consists of the following steps, which should be performed in the order listed.

Hardware straps

DSU physical installation

Network diagnostic connection

Software configuration

DDS network (or LADs) connection

Dial (or PSTN) network connection (if a DBM is installed)

DSU DTE connection

Verification testing

3550-A2-GB20-20

December 1996

3-1

Page 34
Image 34
Paradyne manual Installing the Model 3551 DSU, Overview