Configuring the Unit
Saving Configuration Options
CAUTION
Be extremely careful when saving configuration options to avoid saving them to the wrong location.
To save edited configuration options:
.Procedure
1.From any configuration option in any option set,
press the 
key to return to the Edit/Save submenu.
2.Press the F1 key below SAVE.
3.Select area (Activ, Remt, Usr1) on the Save to screen.
•If Activ is selected, your changes take effect immediately.
•If Usr1 is selected, your changes are stored for future use.
•If the unit is a control and Remt is selected, the complete set (all option sets available to the unit) of configurations are sent to the tributary and saved to its Activ area.
Remember that you cannot save to the factory- loaded configurations.
Example Using the DCP
In this example, load the configuration options stored in the PTPT area, change Diagnostic Type (Diag Type) under the Diagnostic (DSU) option set from Disr to NonD, change DTE Port under the General option set from EIA232 to V.35, then save the changes to the Usr1 area, and return to the main or
.Procedure
Press the DCP keys indicated by the shading.
Port 1 | DSU | 9.6 C |
Local | Remot |
|
F1 | F2 | F3 |
Local Mode:
Stat Bckup Test
F1 F2 F3
Local Mode:
Bckup Test Confg
F1 F2 F3
Configure:
Opts PList Dir
F1 F2 F3
Load from: |
| |
Activ | Remt | Usr1 |
F1 | F2 | F3 |
Load from:
Remt Usr1 PTPC
F1 F2 F3
Load from:
Usr1 PTPC PTPT
F1 F2 F3
December 1996 |
