COMSPHERE 3550 Series Data Service Units
Table
(4 of 4)
General Configuration Options
DTR Alarm: Disab
Next Enab Disab Prev
Data Terminal Ready Alarm (only displayed when Full Mode is enabled, and a TDM/Flex is not installed). Causes the DSU to generate an alarm if DTR is Off for more than 30 seconds. The DCP displays DTR Alarm and reports the alarm to the NMS.
Enab | Ð | Select if the DSU should generate an alarm when DTR is turned Off for 30 seconds. | ||
Disab | Ð | Select if the DTR lead is to be ignored. | ||
|
| |||
Async→ Sync: Disab |
| |||
Next | Enab | Disab | Prev | |
Enab | Ð | Select to configure the DSU as asynchronous. An | ||||
Disab | Ð | Select to configure the DSU as synchronous. | ||||
|
|
|
|
| ||
AsyncBit/Char: 8 |
|
|
|
| ||
Next | 6 | 7 | 8 | 9 | 10 | Prev |
Asynchronous Bits per Character (only displayed with no TDM/Flex installed). Specifies the length of a character, including the parity bit but excluding the start and stop bits. This configuration option only applies when Async→ Sync is enabled.
6 to 10 | Ð | Select the number of asynchronous bits per character. When Stop Bits is set to 2, 10 will not be | |
|
| displayed. | |
|
|
| |
Stop Bits: 1 |
|
| |
Next | 1 | 2 | Prev |
Stop Bits (only displayed with no TDM/Flex installed). Specifies the number of stop bits in an asynchronous character. This configuration option only applies when Async→ Sync is enabled.
1 to 2 | Ð | Select the number of stop bits to be used. When the AsyncBit/Char configuration option is set to 10, 2 will | |
|
| not be displayed. | |
|
| ||
Overspeed: 2.3 |
| ||
Next | 1.0 | 2.3 | Prev |
Overspeed (only displayed with no TDM/Flex installed). Selects the overspeed range of the
1.0 | Ð | Select the basic overspeed range. Basic range provides 1.0% overspeed in the DTE asynchronous data |
|
| rate. |
2.3 | Ð | Select the overspeed percentage for extended range. Extended range provides 2.3% overspeed in the |
|
| DTE asynchronous data rate. |
December 1996 |
