COMSPHERE 3550 Series Data Service Units
Table C-10
(2 of 3)
TDM/Flex Error Messages
Message
Condition
Action
Invalid timing
A TDM/Flex port (Prt1 or Prt2) was previously selected as the source of external timing when the TDM/Flex was enabled. Now, the TDM/Flex is enabled.
Set TxClkSource to any of the valid timing sources (external timing is set to Ext for the DSU (or ExtBU) and/or the DBM).
| Ext was previously selected as the source | Set TxClkSource to any of the valid timing |
| of external timing when the TDM/Flex was | sources (external timing is set to Prt1 or |
| disabled, and the TDM/Flex is now | Prt2). |
| enabled. |
|
|
|
|
No 1.2 @ 56K,64K | A TDM/Flex port is configured for a | Correct the problem in one of two ways: |
| synchronous rate of 1200 bps and the | 1. Increase the speed of the port to at |
| DSU rate is set to 56 kbps. | |
| least 2400 bps via the DSU path in the | |
|
| |
|
| PrtSp configuration submenu. |
|
| 2. Set the DSU rate to a value less than |
|
| 56 kbps. |
|
|
|
OnePrt no undspd | Only one TDM/Flex port is active, and an | Disable the port's underspeed |
| attempt is made to configure it for | configuration option via the appropriate |
| underspeed; no underspeed port is | path (DSU or DBM) in the PrtSp |
| required. | submenu. |
|
|
|
Port Off Undersp | A TDM/Flex's port is disabled and is also | Correct the problem in one of two ways: |
| set to run underspeed; port that is | 1. Set the port speed to any value but |
| disabled cannot run underspeed. | |
| Disab in the PrtSp configuration | |
|
| |
|
| submenu. |
|
| 2. Select another synchronous port to run |
|
| underspeed via the appropriate path |
|
| (DSU, DBM, or ExtBU) in the PrtSp |
|
| submenu. |
|
|
|
RTS/AnStr Conflc | A port's AntiStreaming and RTS Control | Set RTS Control to DTE via the |
| settings are not compatible. | appropriate path (Prt1 or Prt2) in the MUX |
| For AntiStreaming to be in effect, RTS | submenu. |
|
| |
| Control must be set to DTE. |
|
|
|
|
RTS/TxCrr Conflc | A port's TxCarrSel (Transmitter Carrier | Set Transmitter Carrier Select (TxCarrSel) |
| Select) and RTS Cntrl (RTS Control) | and RTS Control (RTS Cntrl) to |
| settings are not compatible. | compatible settings via the appropriate |
| When a port's TxCarrSel is set to Cntrl, | path (Prt1 or Prt2) in the MUX submenu. |
|
| |
| RTS Cntrl must be set to DTE. When a |
|
| port's TxCarrSel is set to Const, RTS |
|
| Cntrl must be set to FrcOn. |
|
|
|
|
December 1996 |
