Paradyne 8784 manual Health and Status Messages, Yyyyyyyy

4. Monitoring the Unit

Health and Status Messages

The following messages appear in the first column of the System and Test Status screen. The highest priority Health and Status message also appears on all ATI screens on the bottom right.

Table 4-1. Health and Status Messages (1 of 2)

Message	What Message Indicates	What To Do
AIS at DSX-1,	An Alarm Indication Signal	1.	Verify that the unit’s line
Pt n	(AIS) is being received by the		framing and line coding are
	DSX-1 interface.		compatible.
		2.	Contact network provider.
Device Failed	An internal error has been	1.	Provide the 8-digit failure
yyyyyyyy	detected by the operating		code shown (yyyyyyyy) to
	software. yyyyyyyy indicates		your service representative.
	the 8-digit hexadecimal	2.	Reset the unit to clear the
	failure code.
			condition and message.
Download Failed	A firmware download was	Repeat the download.
	interrupted.
EER at DSX-1,	An EER (Excessive Error	1.	Verify the attached
Pt n	Rate) condition has been		equipment coding is
	detected on the DSX-1		compatible.
	interface.	2.	Contact network provider.
EER at Net, Pt n	An EER (Excessive Error	1.	Check the Network
	Rate) condition has been		Performance Statistics
	detected on the network		screen for possible line
	interface at Port n. The		impairments.
	condition is cleared when the	2.	Set the unit to run at a lower
	error rate falls below the
			DSL line rate.
	threshold value currently
	configured.
LOF at DSX-1,	An LOF (Loss Of Frame)	1.	Verify that the network cable
Pt n	condition has been detected		is securely attached at both
	on the DSX-1 interface.		ends.
		2.	Contact network provider.
LOS at DSX-1,	An LOS (Loss Of Signal)	Verify that the interface cable is
Pt n	condition has been detected	securely attached at both ends.
	on the DSX-1 interface. No
	signal is being received on
	Port n.
LOS at Net, Pt n	An LOS (Loss Of Signal)	1.	Verify that the network cable
	condition has been detected		is securely attached at both
	on the network interface. No		ends.
	signal is being received on	2.	Contact network provider.
	Port n, possibly due to a local
	network problem.

8784-A2-GB20-30 February 2001 4-3