Paradyne 8784 manual Self-Test Results Messages, Test Status Messages

4. Monitoring the Unit

Self-Test Results Messages

The results of the last power-on or reset self-test appear in the middle column of the System and Test Status screen.

Table 4-2. Self-Test Results Messages

Message	What Message Indicates	What To Do
CPU Failed	The CPU failed internal	1. Reset the unit and try again.
	testing.	2. Call your service
Device Failed	One or more of the unit’s	representative for
	integrated circuit chips has	assistance.
	failed device-level testing.
DSX-1 Failed, Pt n	The unit failed to internally
	loop data on the DSX-1
	Port n.
Failure xxxxxxxx	An internal failure occurred.	Record the failure code and
	(xxxxxxxx represents an	contact your service
	8-digit hexadecimal failure	representative.
	code for use by service
	personnel.)
Memory Failed	The unit failed memory	1. Reset the unit and try again.
	verification.	2. Call your service
Net DSL Failed, Pt n	The unit failed to loop data on	representative for
	the network DSL circuit of	assistance.
	Port n.
Passed	No errors were detected.	No action is needed.

Test Status Messages

The Test Status messages in the following table appear in the right column of the System and Test Status screen.

Table 4-3. Test Status Messages

Test Status Message	Meaning
511 Test Active, Pt n	A 511 Test and Monitor is active on the DSL Port n network
	interface.
DLB Test Active, Pt n	A Data Terminal Loopback test is active on Port n.
Lamp Test Active	The Lamp Test is active, causing the LEDs on the front panel
	to light.
LLB Test Active, Pt n	A network Line Loopback test is active on Port n.
No Test Active	No tests are currently running.
RLB Test Active, Pt n	A network Repeater Loopback test is active on Port n.

For information on testing, refer to Chapter 5, Testing.

8784-A2-GB20-30 February 2001 4-5