Paradyne 8784 manual Logging In to the Hotwire Dslam, Initiating an ATI Session, Login

2. Using the Asynchronous Terminal Interface

Logging In to the Hotwire DSLAM

You can log in to the Hotwire DSLAM system using either a local

VT100-compatible terminal or a remote Telnet connection.

After you enter your user ID and password, the system displays the Hotwire Chassis Main Menu. See your Management Communications Controller (MCC) documentation for information about selecting the unit from the MCC card selection screen.

Initiating an ATI Session

The Main Menu screen is displayed unless a login ID and password is required or the ATI is already in use.

If the ATI is already in use, the message connection refused is sent to the terminal attempting Telnet access.

If security is enabled and Telnet is used to access the terminal unit directly (you did not log in through the MCC), the system prompts you for a login ID and password.

Login		Hotwire
Slot:	4	Model: 8784

LOGIN

Login ID:

Enter Password:

--------------------------------------------------------------------------------

Ctrl-a to access these functions Exit

If you enter an invalid login ID and password three times, the Telnet session closes or the terminal connection returns to an idle state. Refer to Chapter 7, Security.

2-2 February 2001 8784-A2-GB20-30