Patton electronic 2800 user manual Ports descriptions

OnSite 2800 Series User Manual 1 • General information

Ports descriptions

The OnSite 2800 Series rear-panel ports are described in table 2.

			Table 2. Rear panel ports
Port	Location			Description
10/100 Ethernet	Rear panel	RJ-45 connectors (see figure 2 on page 19 and figure 3 on page 20)
ETH 0/0 (WAN) &		that connect the router to an Ethernet device (e.g., a cable or DSL
ETH 0/1–0/4 (LAN)		modem, LAN hub or switch).
WAN	Rear panel	DB-25 or DB-15 receptacle provides a V.35 or X.21 serial interface for
		leased-line connection to a WAN at rates up to 2 Mbps.
T1/E1	Rear panel	E1—G.703/G.704 with HDB3 or AMI encoding. RJ-48C and dual
		coaxial connectors.
		T1—ANSI T1.403 & AT&T TR54016 with AMI coding/D4 framing or
		B8ZS coding/ESF framing. RJ-48C connector.
Power	Rear panel	The router is available in a DC or AC power input version (see figure 4
		on page 21), labeled as follows:
		AC version (Internal power supply): 100–240 VAC, 50/60 Hz, 1 A
		DC version: +12 V, 1 A (Model 2821, 2802, 2835) or
		+5 VDC 1 A (Model 2805)
Console	Front panel	Used for service and maintenance and available on all OnSite 2800
		models except the OnSite 2805, the Console port (see figure 5), an RS-
		232 RJ-45 connector, connects the router to a serial terminal such as a
		PC or ASCII terminal (also called a dumb terminal).
		IPLink 2805
				IPLink VPN Router

Power

IPLink 2835, 2821, 2802

1 2 3 4

LAN

WAN

IPLink VPN Router

Link	100M	Activity
	0
Enet

Power Run

PowerRun	Link 100M Activity	Link 100M Activity
	Enet 0	Enet 1	Console
			Console port
Console

Link	100M	Activity
	1
	Enet

Figure 5. OnSite 2800 Series front panels

OnSite Model 2800 Series overview 22