
OnSite 2800 Series User Manual | 4 • Serial port configuration |
|
|
Note Use the no shutdown command to enable the serial interface after the configuration procedure.
This procedure describes how to shut down a serial interface
Mode: Administrator execution
Step | Command | Purpose |
|
|
|
1 | node(cfg)#port serial slot port | Selects the serial interface on slot and port |
2 | Shuts the selected interface down | |
|
|
|
3 | Displays the serial interface configuration. | |
|
|
|
Example: Disabling an interface
The example shows how to disable the
2800(cfg)#port serial 0 0
Serial Interface Configuration
Port | : | serial 0 0 0 |
State | : | CLOSED |
Hardware Port | : | V.35 |
Transmit Edge | : | normal |
Port Type | : | DTE |
CRC Type | : | |
Max Frame Length: | 2048 | |
Recv Threshold | : | 1 |
Encapsulation | : |
|
Enabling an interface
After configuring the serial interface or connecting other serial devices to your OnSite 2000, use the no shut- down command to enable the serial interfaces again. When you enable an interface, it has the state OPENED in the show port serial command display.
Note Use the shutdown command to disable the serial interface for any software or hardware configuration procedure.
This procedure describes how to enable a serial interface.
Mode: Administrator execution
Step | Command | Purpose |
|
|
|
1 | node(cfg)#port serial slot port | Selects the serial interface on slot and port |
2 | Enables the interface | |
|
|
|
3 | Displays the serial interface configuration. | |
|
|
|
Serial port configuration task list | 46 |