Patton electronic 3086 manual CLI Configuration Method, Show one of the eight groups, 179

Model 3086 G.SHDSL Integrated Access Device User Guide F • Interworking Functions Information

The Frame Relay Service Interworking functions on the Patton Electronics Model 3086FR are also defined as sixty-four channels. Each channel creates a connection between a single DLCI on the Frame Relay network and a VPI/VCI on the ATM network. The following configuration options are available for each channel in the system.

•VPI—Virtual Path Identifier: ATM side Virtual Path Identifier for the specified connection.

•VCI—Virtual Channel Identifier: ATM side Virtual Channel Identifier for the specified connection

•DLCI—Data Link Connection Identifier: Frame Relay side DLCI for the specified connection

CLI Configuration Method

The following section describes how to configure FRS channel connections using the CLI interface.

The system is made up of eight groups and 64 channels. The group configuration variables apply to all eight channels within that group. Each channel is configured independently and will all run over as single LMI ses- sion or with no LMI running. The FRS (FRF.8) connections are configured using the “frs” directive in the CLI interface. The following commands are available:

Show one of the eight groups

Command: frs show group #

The frs show group # command shows the configuration of te group defined by the # directive. Possible options are 1–8. The following shows an example setup:

fifrs show group 1

Group Level Information: Group A

Group Name:

Group DE Mapping: zero

Group Trans Mode: translate

Group FECN Mapping: zero

Channel Level Information: Channels 1 - 8

---------------------------------------------------------------------

Chn	VPI	VCI DLCI Activate	Tx Pkt G/B	Rx Pkt G/B
chn1	100	200 172 enable	0/0	0/0
chn2	1	101 101 disable	N/A	N/A
chn3	2	102 102 disable	N/A	N/A
chn4	3	103 103 disable	N/A	N/A
chn5	4	104 104 disable	N/A	N/A
chn6	5	105 105 disable	N/A	N/A
chn7	6	106 106 disable	N/A	N/A
chn8	7	107 107 disable	N/A	N/A

Set variable attributes on a specified group

Command: frs set group # <variable> <value>

Note At any point during the typing of the command selecting the “?” will display the possible options available to the user.

Frame Relay Service Interworking (FRF.8) 179