
Management and Configuration
Section 10 Management and Configuration
The management and configuration tools that are supported by the Axis
Network Print Server allow you to:
•Change the print server parameters, i.e. editing the config file
•Receive extended information about the print jobs
•Receive printer port status
•Monitor your printers
•Reset the Axis Network Print Server to Factory Default
Configuration The method you should use to manage and configure your Axis Network Overview Print Server depends on the operating system protocols of your network.
The table below displays which method to use for each supported environment.
Operating System Protocols | Configuration/Management methods | |
|
| |
| Web Browser - See page 92 | |
WLAN, TCP/IP | AXIS ThinWizard - See page 107 | |
FTP - See page 110 | ||
(UNIX, Windows, NetWare Pure IP, OS/2) | ||
telnet - See page 112 | ||
| ||
| SNMP - See page 114 | |
|
| |
IPX/SPX (NetWare) | Novell Utilities - See page 119 | |
|
| |
| Web Browser - See page 92 | |
AppleTalk over TCP/IP | AppleTalk_cfg method - See page 45 | |
| ||
|
|
Note:
BOOTP and TFTP are powerful tools for configuring the Axis Network Print Server. Refer to the documentation for the BOOTP/TFTP server on your system for specific information.
Using a Web Browser for Print Server Management
Once you have established the Axis Network Print Server in the TCP/IP environment, as described in “Assigning an IP Address to the Print Server” on page 16, you are free to access the Axis Network Print Server Web pages from any standard Web browser.
The Web interface of the Axis Network Print Server is divided into two modes of operation, User mode and Admin mode:
User In User mode you can change language, but you have no rights to change any other parameters. However, if you have access rights to the Admin mode, you can change some of the basic parameters from User mode via the Configuration Wizard. This mode is intended for regular users who are only interested in using the print server's interface for checking print jobs or viewing printer properties. If you want to change any other of the print server's settings, you must enter the Admin mode.
92 | AXIS 5900 User’s Manual |