
Section
19
Audio Adjustments
Note
If you make adjustments, Custom curve is up- dated.
Adjusting loudness
Loudness compensates for deficiencies in the low- and
1Touch LOUDNESS on the audio function menu.
2Touch c on the LOUDNESS setting to turn loudness on.
# To turn loudness off, touch d.
3Touch c or d on the MODE setting to select a desired level.
Each time you touch cor d selects level in
the following order:
LOW
Using subwoofer output
This unit is equipped with a subwoofer output which can be turned on or off.
!When the subwoofer output is on, you can adjust the
1Touch SUB WOOFER on the audio func- tion menu.
# When the PREOUT setting in the initial menu is FULL, you cannot select SUB WOOFER.
2Touch c on the SUBWOOFER setting to turn subwoofer output on.
# To turn subwoofer output off, touch d.
3Touch c or d on the PHASE setting to select the phase of subwoofer output. Touch d to select normal phase and NORMAL appears in the display. Touch c to
select reverse phase and REVERSE appears in the display.
4Touch c or d on the LEVEL setting to adjust the output level of the subwoofer. Each time you touch cor d increases or de- creases the level of the subwoofer. +6 to
5Touch c or d on the FREQUENCY set- ting to select
Each time you touch cor d selects
Only frequencies lower than those in the se-
lected range are outputted from the sub- woofer.
Using nonfading output
When the nonfading output setting is on, the audio signal does not pass through this unit’s low pass filter (for the subwoofer), but is out- putted through the RCA output.
1Touch NON FADING on the audio func- tion menu.
# When the PREOUT setting in the initial menu is only FULL, you can select NON FADING. (Refer to page 107.)
2Touch c on the NON FADING setting to turn non fading output on.
# To turn non fading output off, touch d.
3Touch c or d on the LEVEL setting to adjust the output level of the non fading. Each time you touch cor d increases or de- creases the level of the non fading. +6 to
displayed as the level is increased or decreased.
86
En