Polycom RMX 2000 Administrator’s Guide
B-7
Internal MCU reset Possible explanations:
•McmsDaemon reset due to policy decision: [Process
failed [abs crash counter: crash counter]: process
name].
•McmsDaemon reset due to policy decision: [Process
failed [abs crash counter: crash counter]: process
name]; Cannot reset while system is in DEBUG
mode.
•Power down signal was detected.
•[CS Component Failure; unit type:
[NonComponent\CSMngnt\CSH323\CSSIP]\CS
Component Failure; unit type: (invalid: [unit type])\No
connection with CS]; Cannot reset while system is in
DEBUG mode.
•Reset cause unknown: [reset source]\Restore
Factory Defaults - [mcu restore name]\CM_Loaded
indication repeated; boardId: [boardId]\reset from
Cards process - simulation\No connection with MPM;
board Id:[boardId]\SmMfaFailure - boardId: [boardId].
Status: [status], problem bitmask:
[problemBitMask]\MPM failure, boardId:
[slotId]\Switch failure\No connection with Switch.
Internal System configuration during
startup
System configuration during startup.
Invalid date and time Invalid date and time:
MCU year ([year]) must be 2000 or later.
Invalid MCU Version MCU Version: [Major.Minor.release.internal].
Invalid System Configuration
IP addresses of Signaling Host and
Control Unit are the same
IP Network Service configuration modified IP Network Service was modified.
Reset the MCU.
IP Network Service deleted IP Network Service was deleted.
Reset the MCU.
Table B-1 Alarms (Continued)
Alarm Code Alarm Description