Polycom DOC2237A manual Item # Polycom P/N Description Quantity

MGC Hardware and Installation Manual

Because of heat considerations, the MCU must be installed with the Control Unit Module placed on the left bottom.

1.Check that all the parts are in the kit.

The kit should contain the following items:

Table 2-1: 19” Rack Mounting Kit

Item #	Polycom P/N	Description	Quantity
1	MEC2063A	23" TO 19" Mounting Bar MGC-	2
		100 at 90 Degrees
2	SCR2005A	Screw 10-32 x 1/2” Allen S/H	8
		ST/ST
3	WAS2003A	Washer M5 Spring Latch Loc.	8
		ST\ST
4	WAS2004A	Washer M5 Flat ST/ST	8

2.Make sure that the MCU power is turned OFF and it is disconnected from the AC and DC power.

Remove the side covers as described on page 2-4.

3.If the MCU is a standalone unit, you must first remove the side covers, and add the mounting brackets to a 23” rack (see pages 2-4 to 2-6).

4.Attach the two mounting bars to the MCU as follows:

a.Fit the spring washer (Item #3) onto the screw (#2).

b.Fit the flat washer (Item #4) onto the screw.

Item #4 Item #3

c.Take the two mounting bars (Item #1) from the kit and attach them to the MGC-100 unit with the screws (with the attached washers, as described in step b).

2-7