Chapter 2 - Hardware Installation
Connecting the MGC-50 to the ATM Network
The MGC-50 can be connected to an ATM network. The type of connection used differs according to the ATM Network Interface card installed in the MCU.
If an ATM-25 network interface card is installed, connect the 8-pin
RJ-45 connector of the network cable to the NET RJ-45 jack on the rear panel of the MGC.
Figure 2-15: ATM-25 network connection
If an ATM-155 network interface card is installed, first remove the rubber plug covering the jack. Then connect the fiber optics cable connector to the jack on the rear panel of the MGC.
ATM 155 t k
Figure 2-16: ATM -155 network connection
The ATM network properties must be defined in the Network Services, for details, see the MGC Administrator’s Guide, Chapter 3.
