Section VIII - Power$ync II™ Operation
The following menu identifies the day of the week for which schedule changes are to be made and the sequence that is to be scheduled.
DAY : MONDAY SEQ : ABCD
1 > 00:00 SQ:0 2 > 00:00 SQ:0 3 > 00:00 SQ:0 4 > 00:00 SQ:0 5 > 00:00 SQ:0 6 > 00:00 SQ:0 7 > 00:00 SQ:0 8 > 00:00 SQ:0 9 > 00:00 SQ:0
When this display is shown, the first time slot will be flashing at a fast rate. Use the UP or DOWN arrow keys to identify the time slot to edit. When the correct time slot is flashing, press F1. This will start the hours slot flashing at a slow rate, indicating that the controller is ready to accept a new number. Use the UP or DOWN arrow keys to change the hour number. When the hour number has been set, press ENTER to accept the number and start the minute number flashing. Follow the same procedure to set the minutes correctly as was done with the hours. Press ENTER to accept the number and move to the sequence number for editing.
DAY : MONDAY SEQ : ____
1 > 00:00 SQ:0 2 > 00:00 SQ:0 3 > 00:00 SQ:0 4 > 00:00 SQ:0 5 > 00:00 SQ:0 6 > 00:00 SQ:0 7 > 00:00 SQ:0 8 > 00:00 SQ:0 9 > 00:00 SQ:0
Use the UP or DOWN arrow keys to scroll through the sequence numbers. As the numbers scroll, the actual compressor sequence will be displayed in the area to the right of SEQ:. When the desired sequence is displayed, press ENTER.
When ENTER is pressed, the edited time slot will once again begin to flash.
DAY : MONDAY SEQ : ____
1 > 00:00 SQ:0 2 > 00:00 SQ:0 3 > 00:00 SQ:0 4 > 00:00 SQ:0 5 > 00:00 SQ:0 6 > 00:00 SQ:0 7 > 00:00 SQ:0 8 > 00:00 SQ:0 9 > 00:00 SQ:0
With the schedule just edited flashing again, follow the same procedure to change the next schedule if needed. If no other changes are required, press ENTER to return to Network Configuration Menu 3.
If an invalid time is entered during the scheduling procedure, the following message will be displayed:
YOU HAVE ENTERED AN INVALID TIME
PLEASE PRESS ENTER TO CONTINUE EDIT
Press ENTER to correct the invalid time.
If no other changes are required, press ENTER to return to Network Configuration Menu 2. Press the UP arrow key to move to Network Configuration Menu 3.
NETWORK CONFIGURATION MENU 3
TRANSFER NETWORK DATA | ➔ PRESS F1 |
SETUP NETWORK PRESSURES | ➔ PRESS F2 |
UP FOR NEXT MENU/DOWN FOR PREVIOUS MENU
Press F1 to transfer information to a new machine added to the network. Otherwise, network information is transferred to all machines on the network whenever these menus are exited.
Quincy Compressor® - QSD™ | 49 |
|
|
