When [QUICK SEND MODE] is set to [2TOUCH]

1 Check that the destination device is turned on.

2 Turn the mode dial to 5/Kand shoot the picture. 3 Press the Q (Quick Review) button.

• A screen appears confirming whether to send the image.

4 Press the MENU/OK button.

When the Bluetooth® function is used for the first time, a screen appears confirming whether to search for a destination device.

If you have already searched for a destination device, a list of destination devices appears. Go to Step 6.

If the camera is connected using a

serial connection, a screen appears confirming whether to disconnect the serial connection. Select [YES] and press the MENU/OK button and go to Step 6.

If the camera is connected using a wireless LAN connection, a screen appears confirming whether to disconnect the wireless LAN connection. Select [YES] and press the MENU/OK button, and go to Step 5 or Step 6. (Only for Caplio 500SE-W)

5 Press the $ button to select [YES] and then press the MENU/OK button.

The camera begins searching for a destination device and a list of destination devices appears when the search is completed.

By default, up to five devices can be discovered, but you can change this to

search for any number of devices between one and ten. (GP.176)

6 Press the !" buttons to select the desired destination device.

If the desired destination device is not listed, press the ADJ. button to search again for destination devices.

Select a destination device and press the $ button to display information about the destination device.

To delete a destination device from the

list, select the device and press the D (Delete) button.

Using the Bluetooth® Function

8

173

Page 176
Image 176
Ricoh 500SE manual 173, When Quick Send Mode is set to 2TOUCH