Automatically Connecting to a Previously Connected Device (BT AUTO CONN)

When [BT AUTO CONN] on the Expanded Settings menu is set to [ON], the next time the camera is turned on, the camera automatically searches for and connects to the previously connected Bluetooth® GPS unit. This is convenient if you want to use the same Bluetooth® GPS unit to which your camera previously connected.

Set [BT AUTO CONN] to [ON].

1 Display the Expanded Settings menu.

For the operating procedure, see P.155.

For Caplio 500SE-W, check that [CHANGE COM] is set to [BT] on the Expanded Settings menu. (GP.193)

2 Press the " button to select [BT AUTO CONN] and press the $ button.

3 Press the !" buttons to select [ON].

4 Press the MENU/OK button, or

#button and press the MENU/ OK button.

Note ----------------------------------------------------------------------------------------------

To automatically connect to a previously connected device after setting this function, turn off the camera and then turn it on again. The camera automatically connects to the previously connected Bluetooth® GPS unit.

If the previously connected device is not detected (GP.154) or [CHANGE COM] is set to [W-LAN] (only for Caplio 500SE-W) (GP.193), no connection is established even if [BT AUTO CONN] is set to [ON].

Use this function for a Bluetooth® GPS unit only.

Using the GPS Function

9

183

Page 186
Image 186
Ricoh 500SE manual 183, Set BT Auto Conn to on