Setting Up the Printer
L Push the cable of the connected harness into the groove for the ca- ble.
2
ZAEP091E
M Attach cover 1 (A) and secure cov- er 1 to the printer fastening the screw (B).
Note
❒Make sure the core of the screw is pulled out slightly before in- serting it.
1 |
2 |
ZAEP671E |
N Attach cover 2 and secure cover 2 to the printer inserting the two screws.
O Turn the adjuster at the center bottom of the paper feed unit clockwise until it touches the floor.
ZAEP100E |
P Put the seal directly below the pa- per size display on the front of the paper feed tray.
Note
❒If PS440 is installed, use the tray number seal included with the printer.
❒If PS420 is installed, use the pa- per size seal included with the printer.
❒After installing all options, print a configuration page to confirm the installation. If the new de- vice is listed in the column of configuration options, then it has been properly installed. For more information, see P.54 “Printing a Configuration Page”.
ZDEP060E
24
