Installing Options
Installing Bypass Tray Type 270
Preparation
The installation procedure for in- stalling the bypass tray when the duplex unit is not yet installed is described below.
If the duplex unit is already in- stalled, remove the holder cover.
Note
❒If you install the duplex unit and the bypass tray unit, the duplex unit must be installed first.
❒If the duplex unit is already in- stalled, perform steps A to C and then go to step H.
A Confirm that the box contains the following items.
1
2
3
ZAEP430E
1.Holder
2.Socket screws (2 pcs)
3.Wrench
•Installation Guide
Note
❒If the duplex unit is already in- stalled, the holder is no longer required.
B Turn off the printer, and remove all cables and cords from the printer.
C Remove the adhesive tape and the packing materials.
Important | 2 |
❒ Do not remove the adhesive |
tape (A) holding the tray and cable until the connector is at- tached in step K.
ZAEP420E |
ZAEP530E |
Note |
❒If the duplex unit is already in- stalled, go to step H.
31
