Loading Paper

Loading Paper in Bypass Tray Type 270

Note

Paper sizes supported by the by- pass tray are in the approximate range of 90 - 297 mm (3.54" - 11.69") in width, and 148 - 432 mm (5.83" - 17.00") in length.

To specify a custom size with the operation panel, see "Specifying a Custom Paper Size for the Bypass Tray" in the Printer Reference in- cluded as a PDF file on the CD- ROM.

If you load a custom or unique pa- per size, set the paper size using the operation panel.

A Open the bypass tray.

ZAEY040E

B Lift the paper guide lever.

ZAEY210E

Note

Swing out the extender to sup- port paper sizes longer than A4

short-edge feed (Metric version) or 8 1/2" ⋅ 11" short-edge feed (Inch version).

C Load the paper and adjust the pa-

2

per guides to the sides of the pa-

per.

ZAEY220E

Important

Confirm the print side of OHP transparencies. Some OHP transparencies can be printed on only one side.

Note

Do not stack paper over the lim- it mark. If you do, skew images or paper misfeeds might occur.

When you set a custom size or thick paper in the bypass tray, do not stack paper above the lower limit mark of the bypass tray.

To avoid paper multi-feeds, shuffle sheets before setting them in the tray.

Load the paper face down onto the tray.

Important

If the paper guides do not match the paper size, skew images or paper misfeeds might occur.

49

Page 65
Image 65
Ricoh AP3200 setup guide Loading Paper in Bypass Tray Type, Open the bypass tray, Lift the paper guide lever