Sagem ADR 155C Management and Administration ports, Comm Interface, Equipment side VT100 or PC

1 - INSTALLATION AND COMMISSIONING

NOTE: Two LEDs are linked to the "ETH" port:

	• LED, "Activity", green colour							: Trafic status indicator,
	• LED, "Link", yellow colour							: Link status indicator.
1.3.2.2 - Management and Administration ports
	"COMM" Interface:
	Ports		RS232, connecting VT100 standard console or emulation
	Bit rate		19200 bauds (8 data bits, no parity bit and 1 stop bit),
	Connector		Female 9-way HE5
						5	1
						9	6
	Pin N°			Signal name					Comments
	1				DCD	Connected to DSR
		6			DSR	Data Set Ready (to DCE)*
	2				RX	Received data (to DCE)*
		7			RTS	Request To Send (from DCE)*
	3				TX	Transmitted data (from DCE)*
		8			CTS	Clear To Send (to DCE)*
	4				DTR	Data Terminal Ready (from DCE)*
		9			RI	Ring Indicator (not connected)
	5				GND	Ground
	* The ADR155C is seen as DCE
	Connection cable		See below.
	Equipment side								VT100 or PC
		"COMM"								side

Male 9-way connectorFemale 9-way connector

		Wiring diagram
1	6	1
		6
5	9	9
		5

Installation and User Guide - N56717020101

Page A1-8 No reproduction or communication without the written consent of SAGEM SA