Sagem ADR 155C manual LPT Lower order Path Termination, LPA Lower order Path Adaptation

2 - OPERATION

Alarms	Description	Severity
LPT : Lower order Path Termination
SD-V5 (VC12)	Signal Degrade –V5	minor
SD-B3 (VC3)	Signal Degrade –B3	minor
LO-SLM	Low order Path – Signal Label Mismatch	Non-alarmed
LO-RDI	Low order Path – Remote Defect Indication	minor
LO-UNEQ	Low order Path – Unequipped	Non-alarmed
LPA : Lower order Path Adaptation
LO-SLM	Low order Path – Signal Label Mismatch	Non-alarmed
PPI : PDH Physical Interface
LOS	Loss Of Signal	minor
AIS	Alarm Indication Signal	Non-alarmed
SETS : Synchronous Equipment Timing Source
T3 LOS	Loss Of Signal on T3 sync input	minor
T1 LOS	Loss Of Signal on T1 sync input	Non-alarmed
T2 LOS	Loss Of Signal on T2 sync input	Non-alarmed
T4 - Failure	Failure on T4 synchronization output	minor
Local equipment
Local user	Remote indication 1	Non-alarmed
inputs # 1
Local user	Remote indication 2	Non-alarmed
inputs # 2
Local user	Remote indication 3	major
inputs # 3
Local user	Remote indication 4	minor
inputs # 4
Remote equipment
Far user inputs	Remote indication 1	Major *
# 1
Far user inputs	Remote indication 2	Minor *
# 2
Others
Message	Card configuration	major
Message	Defective card	major
Message	Missing card	major

Table 2-10 : Alarms and severity (2/2)

*If the equipment configured is declared centre site.

Installation and User Guide - N56717020101

Page A2-14 No reproduction or communication without the written consent of SAGEM SA