Sagem ADR 155C manual Connecting on ADR LAN1 card, Connecting ADR LAN1 card input

1 - INSTALLATION AND COMMISSIONING

1.3.4 - Connecting on ADR LAN1 card

	ADR LAN1			10/100 HALF/FULL
	STATUS
			ETH
LED		STATUS

HALF/FULL

Green	Red
ON	OFF	Card in service
ON	ON	Card in alarm
OFF	OFF	Hardware default (fuse)
OFF	ON	Card out of service
Flashing		Autotest default

ETH

	Contact 1		Contact 8
1	: TX_ETH_TIP	5 : NC
2	: TX_ETH_RING 6		: RX_ETH_RING
3	: RX_ETH_TIP 7		: NC	NC : Reserved
4	: NC	8	: NC
	Yellow LED	: link status
	ON	: correct link
	Green LED	: traffic status
	ON	: on reception

Yellow LED : Ethernet interface type (Half or Full Duplex)

ON : Full duplex

10/100

Yellow LED : Ethernet interface bite rate

ON : 100 Mbit/s

		Figure 1-5 – Connecting ADR LAN1 card input
"ETH" Interface :
Port		Traffic Ethernet interface operating at 10 or 100 Mbit/s in half-duplex or full-
		duplex mode according to the mode used by the interlocutor (dynamic
		adaptation of the Ethernet port on each new log-in of the interlocutor),
Connector		Ethernet 10 or 100 BaseT - RJ48 Type (Shielded RJ45).
			Pin 1	Pin 8
				Front view
	Pin N°		Signal name		Comments
	1		TX_ETH_TIP		Ethernet output (hot point)
	2		TX_ETH_RING		Ethernet output (cold point)
	3		RX_ETH_TIP		Ethernet input (hot point)
	4		NC		Reserved
	5		NC		Reserved
	6		RX_ETH_RING		Ethernet input (cold point)
	7 and 8		NC		Reserved

NOTE: Two LEDs are linked to the "ETH" interface:

•	LED, "Activity", green colour	: Trafic status indicator,
•	LED, "Link", yellow colour	: Link status indicator.

Electrical characteristics compliant with the IEEE 802.3U

Installation and User Guide - N56717020101

Page A1-16 No reproduction or communication without the written consent of SAGEM SA