Sagem ADR 155C 2.3 G.703 2 Mbit/s Synchronization port, 2.4 G.703, 21 x 2 Mbit/s traffic port

1 - INSTALLATION AND COMMISSIONING

1.3.2.3 - G.703 2 Mbit/s Synchronization port

"SYNC" Interface
Ports			Two G.703 2MHz external synchronization inputs (T3) and one G.703 2MHz
			clock output (T4) compliant with ITU-T G.703 Recommendation
			(§ 10.3 for input port, § tab.10 for output port)
Bit rate			2,048 Mbit/s ± 50 ppm,
Impedance			120 Ω balanced,
Connector			Female 9-way HE5 (120 Ω).
			5		1
			9		6
	Pin N°			Signal name	Comments
	1			GND	Ground
		6		TX1 RING (T4-)	Output T4-1 (cold point)
	2			TX1 TIP (T4+)	Output T4-1 (hot point)
		7		RX2 TIP (T3+)	Input T3-2 (hot point)
	3			RX1 TIP (T3+)	Input T3-1 (hot point)
		8		RX1 RING (T3-)	Input T3-1 (cold point)
	4			RX2 RING (T3-)	Input T3-2 (cold point)
		9		NC	Reserved
	5			NC	Reserved

NOTA : The shielding of the connector case is connected to the subrack front panel ground

1.3.2.4 - G.703, 21 x 2 Mbit/s traffic port

"E1 INPUT" and "E1 OUTPUT" Interface

ports	21 x 2 Mbit/s traffic ports compliant with the ITU-T G.703 Recommendation
	(§ 6.3 for input port, § tab.6 for output port)
Bit rate	2,048 Mbit/s ± 50 ppm,
Code	HDB3,
Impedance	120 Ω balanced,
Connector	SUB D HD female 44 pins supporting L907 cable (21 ports).

This interface uses two connectors : E1 INPUT connector for inputs (named RX) and E1 OUTPUT connector for outputs (named TX)

15	1
30	16
44	31

Installation and User Guide - N56717020101

Page A1-10 No reproduction or communication without the written consent of SAGEM SA