Sagem ADR 155C Revertive, 010b, SD-V5 threshold, A8H, Mbit/s, 60 %, Configuration parameters 3/6

2 - OPERATION

	Configuration parameters per functional blocks	Default
		value
LPC : Lower order Path Connection
Connection switch		Not put into
		service
	Connection name (configurable according to M.1400 §13)	No name
	Type : bi-directional / unidirectional	MONO
SNC protection
	Type	SNC/I
	Protection mode	MONO
	Revertive authorization (path by path) : return after a WTR time-delay to
	the working link when the fault (SF or SD) causing the switch has
	disappeared.
	"Revertive"	"no"
	Wait Time to Restore (WTR) period (common to all paths): in revertive
	mode, period following restoration of nominal operation ; configurable
	from 0 to 15mn in one-second steps
	"WTR"	"1 mn"
	SF and SD fault persistence (path by path) : configurable from 0 to 10s in
	100ms steps
	"Hold-off time"	"0 ms"
LPT : Lower order Path Termination
Signal label (VC12) transmitted, expected and received; "Label" :
-	"Transmitted",: "000b" no connection or "010b" (asynchronous)
	if connection (not configurable by the operator)	"010b"
- "Expected", possible value : "001b" equipped without specification or
	"010b" (asynchronous)
-	"Received".
SD-V5 threshold (VC12) configurable from 10-5to 10-8for VC12
	"SD-V5 threshold"	"10-6"
ADRLAN Card
Signal label (VC3# i) transmitted, expected and received; "Label" :		"A8H"
-	"Transmitted", not configurable
-	"Expected", not configurable	"A8H"
-	"Received".
Bit rate : Forcing the Ethernet port bit rate		10 Mbit/s
The bit rate is imposed on or self-adaptive to the connection (selection of
the maximum proposed bit rate on the half- or full-duplex bus)
Flow control
- LAN towards VC3_# i		60 %
- VC3_# i towardsVC3_# j or LAN		60 %

Table 2-3 – Configuration parameters (3/6)

Installation and User Guide - N56717020101

Page A2-4 No reproduction or communication without the written consent of SAGEM SA