2 - OPERATION
2.5 - Alarms processing
LEDs and pushbuttons
The following tables give the meanings of the lit LEDs and the actions initiated by using the pushbuttons÷.
LEDs :
Monitored | Designation | Colour | Status | Meaning |
item |
|
|
|
|
Motherboard | "ON" | Green | On | In service card |
|
|
| Flashing | |
|
|
| Off | Not powered equipment or not |
|
|
|
| run software |
| "ALA M" | Red | On | Major alarm |
| "ALA m" | Yellow | On | Minor alarm |
Ethernet | "Activity" | Green | On | On reception |
(management port |
|
| Off | No traffic |
or ADRLAN card) | "Link" | Yellow | On | Correct Link |
|
|
| Off | No link |
÷Traffic cards | "STATUS" |
|
| See table below |
"STATUS"LEDs on ADR IC 1.x, ADR LAN and ADR 21E120 cards :
Green LED | Red LED | Meaning |
|
|
|
On | Off | Card in service and configured |
On | On | Card in service and in alarm |
Off | Off | Hardware default on card (fuse) |
Off | On | Card out of service (not configured) |
÷Flashing |
|
Pushbuttons :
Designation | Location | Role | Action initiated |
"ACK" | Front panel | Alarm | Pressing disables the outgoing alarm |
|
| acknowledge | loops. The visual alarm is kept. |
"INIT | Motherboard | Configuration | "Factory" Configuration reload |
CONFIG"* |
| reload |
|
*: To activate "INIT", keep button pressed for at least 5 seconds. This button is inaccessible (and unused) in normal operation. It is necessary to remove the cover to access it.
Installation and User Guide - N56717020101
Page | No reproduction or communication without the written consent of SAGEM SA |
