Replacing the print cartridge
When you notice that the print becomes light or Ink Low. Install new ink cartridge appears in the
display, replace the print cartridge. You should replace the cartridge with the same one which was provided with the machine.
The part number for replacement cartridges are:
•mono:
1Prepare a cartridge.
•Take out a cartridge from its packaging and carefully remove the tape covering the printhead.
•Hold the cartridge by the colored top or black areas only. Do not touch the copper area.
2Press Cartridge Change.
The Cartridge Carrier moves to the install position.
3Open the Control Panel and Cartridge Compartment cover.
4Push down the cartridge, and remove it.
5To load the cartridge insert the cartridge below the metal clip and pointing down at the front. When the cartridge is pushed to the back of the cartridge carrier lift the front of the cartridge up until it clicks into place.
• If the cartridge moves loosely in the Carrier, it has not clicked into place. Repeat this step.
6Replace the Cartridge Compartment Cover and Control Panel.
7Press Enter.
8Press 1 for new cartridge, or 2 for the old one.
•In case you selected the 1:New, the alignment form will print.
•When you put in a new cartridge, you must choose 1:New.
•When you put in a used cartridge, choose 2:Used. This helps you to check the correct amount of ink you have left.
•If you mix up several used cartridges, it is not possible to check the correct amount of remaining ink. Once you have put in a new cartridge, use it until it is completely exhausted.
9Enter the number which represents the straightest line, and press Enter.
8.3
CARE AND | MAINTENANCE |
|
|
CARE AND | MAINTENANCE |
