Recording your TAM message
The TAM message is an outgoing message (OGM) which plays whenever a call comes in and the machine is in TAM Mode. For more information about reception modes, see "Receiving in TAM mode
1Press and hold OGM until you hear a beep.
2Speak into the microphone on the Control Panel within 30cm range from the time you see Record in the dis- play.
•You can record a message which lasts up to 20 seconds.
•You are advised to record a message of less than 15 seconds in duration to prevent the incoming faxes from malfunctioning due to a long message.
•Press Stop/Clear or OGM if you want to stop recording before the time is up.
•After the message has been recorded, the machine briefly displays the date and time when the message was recorded. Then, it displays the elapsed time as the message plays back automatically.
Checking your TAM message
The TAM message plays back when your machine is in TAM Mode and receives a call.
Press OGM.
•The display shows the time when the message was recorded. The display then counts down the seconds as the message is playing back.
Monitoring an incoming call
Call Monitoring is useful for screening calls in case you do not want to be disturbed by the person calling. To use this feature, you have to first set Call Monitoring ON through the TAM Options. To learn how to set this feature on or off, see "Call Monitor" on page 6.10.
1When the call monitor option is on and an incoming message is being recorded, you hear the caller’s voice through the speaker.
2Lift the handset to speak to the caller.
•The machine stops recording the caller’s message and you can speak directly to the caller.
•If there is a power failure while recording a caller’s message, it will not be recorded.
4.2
