Schneider Electric PM810 Firmware, Series 800 Power Meter Features, PM820 PM850 PM870

63230-500-225A2	PowerLogicTM Series 800 Power Meter
3/2011			Chapter 1—Introduction
Features
	Table 1–7: Series 800 Power Meter Features
		PM810	PM820	PM850	PM870
	True rms metering to the 63rd harmonic	(3)	(3)		
	Accepts standard CT and PT inputs				
	600 volt direct connection on voltage inputs				
	High accuracy — 0.075% current and voltage (typical conditions)				
	Min/max readings of metered data				
	Input metering (five channels) with PM8M22, PM8M26, or PM8M2222				
	installed
	Power quality readings — THD				
	Downloadable firmware				
	Easy setup through the integrated or remote display (password protected)				
	Setpoint-controlled alarm and relay functions				
	On-board alarm logging				
	Wide operating temperature range: –25° to +70°C for the power meter				
	unit
	Communications:
	On-board: one Modbus RS485 (2-wire)				
	PM8RD: one configurable Modbus RS232/RS485 (2- or 4-wire)				
	Active energy accuracy: ANSI C12.20 Class 0.2S and IEC 62053-22				
	Class 0.5S
	Non-volatile clock	(1)			
	On-board data logging	(2)	80 KB	800 KB	800 KB
	Real-time harmonic magnitudes and angles (I and V):
	To the 31st harmonic	(3)		—	—
	To the 63rd harmonic		—		
	Waveform capture
	Standard	—	—		
	Advanced	—	—	—	
	EN50160 evaluations
	NOTE: The PM850 performs EN50160 evaluations based on	—	—		
	standard alarms, while the PM870 performs EN50160 evaluations
	based on disturbance alarms.
	ITI (CBEMA) and SEMI-F47 evaluations
	NOTE: The PM870 performs ITI (CBEMA) and SEMI-F47	—	—	—	
	evaluations based on disturbance alarms.
	Current and voltage sag/swell detection and logging	—	—	—	

(1)The Time Clock in the PM810 with PM810LOG is non-volatile. However, it is volatile in the PM810.

(2)The on-board data logging memory in the PM810 with PM810LOG is 80 KB, but it is not available in the PM810.

(3)The PM810 with PM810LOG and the PM820 monitor distortion to the 31st harmonic. Harmonic distortion is not monitored in the PM810.

Firmware

This user guide is written to be used with firmware version 11.xx and above. See “Identifying the Firmware Version, Model, and Serial Number” on page 70 for instructions on how to determine the firmware version. To download the latest firmware version, follow the steps below:

1.Using a web browser, go to http://www.Schneider-Electric.com.

2.Locate the Search box in the upper right corner of the home page.

3.In the Search box enter “PM8”.

4.In the drop-down box click on the selection “PM800 series”.

5.Locate the downloads area on the right side of the page and click on “Software/Firmware”.

6.Click on the applicable firmware version title (i.e. “PowerLogic Series 800 Power Meter Firmware version 12.100”).

7.Download and run the “xxx.exe” firmware upgrade file provided.

© 2011 Schneider Electric. All Rights Reserved. 7