Seagate 240 DDS-4 manual Rear panel of external Scorpion

Scorpion 240 Autoloader Installation Manual		A-19
Figure 6. Rear panel of external Scorpion 240
	SCSI ID selector	On/Off switch

+

–

68-pin wide SCSI	AC Power connector
connectors

Connecting the SCSI interface cable

The Scorpion 240 provides two 68-pin, shielded connectors on the rear panel of the enclosure. Either connector can be used as a SCSI IN or SCSI OUT connection (you can use either connector to attach the drive to the host computer or to another SCSI device).

Turn off your computer and all SCSI devices. Then attach a SCSI cable from the host adapter or from another (unterminated) SCSI device to the Scorpion 240

Note: The Scorpion 240 will not work in a SCSI-1 environment.

SCSI termination

If the Scorpion 240 is the last device or the only device in a SCSI chain, you must install a terminating plug on the unused SCSI connector. See Figure 7 on the following page for two SCSI termination examples. You can purchase a terminator for the Scorpion 240 (part number 10006525-001) on the web at http://buytape.seagate.com.