
Configuring the conference system via the central unit
Checking the system and detecting problems – “System”
The “System” submenu provides information on the current status of your confer- ence system and any errors that have occured.
After
The central unit also checks the conference system for errors during a running conference and, if necessary, shows the following icons to indicate these errors.
Direct Access | 30 Units |
22
N M L K
Icon
Meaning
Warning triangle
Cable fault icon
Structural change icon
To ensure
Carry out the following steps before starting the conference.
This allows you to diagnose and remedy errors in your conference system at an early stage.
Set up your entire conference system.
If you do not yet know the final number of participants, take the maximum number of participants as a starting point. Connect the corresponding number of conference units to the central unit.
Switch the central unit on.
The central unit performs a
If the number of participants increases after an
If an error or a warning occurs, proceed as follows:
Eliminate the error (see the following tables).
After error elimination, perform a manual
Main Menu
System
Diagnostics
Select and call up the “Diagnostics” submenu
Diagnostics
Temperature
Bus Statistics
Start
No
Select and call up the “Start
Start
Yes
No
Start
No
Select the desired setting; apply the setting
The central unit now checks if the reported error still occurs. If the error has been eliminated, the corresponding error icon will go off after the
34