Optional Settings

Setting 24: MULTI TTI

If you are using Department Control, you can press 1 to have the department name (the name associated with the department code entered by an operator to access the fax) appear at the top of each transmitted document. This will appear in place of the name entered in Entering Your Name and Fax Number in Chapter 1. Press 2 to turn Multi TTI off (the sender’s name entered in Chapter 1 will appear).

Initial setting: 2

Setting 25: BEEP LENGTH

This sets the duration of the beep that signals the end of transmission, reception, or copying. Press 1 for 3 seconds, 2 for 1 second, or 3 for no beep.

Initial setting: 1

Setting 26: TELEPHONE BILLING CODE

This setting allows you to use Department Codes or direct billing codes for telephone billing on a PBX. (Your dealer must first activate Department Control or direct billing code entry.) Press 1 to turn telephone billing on, or 2 to turn it off.

Initial setting: 2

If you pressed 1, the BILLING CODE DIAL selection will subsequently appear. Press 1 if your PBX must receive the billing code before dialing a telephone number, or 2 if it must receive the billing code after dialling a telephone number. (Refer to your PBX manual or consult your PBX administrator for this information.)

Note: If you select AFTER for the BILLING CODE DIAL selection, you must press the REDIAL key after dialing if you use the SPEAKER key.

Setting 27: DEPARTMENT CODE DIGITS

Use this setting if you are using Telephone Billing and need to change the number of digits of Department Codes to accord with your PBX’s telephone billing system. Enter any number from 3 to 9.

Initial setting: 4

6. Option Settings

169

Page 171
Image 171
Sharp FO-6700 operation manual Setting 24 Multi TTI, Setting 25 Beep Length, Setting 26 Telephone Billing Code