Sharp PG-M25X Image Projection, Basic Procedure, Press on the projector or on the GyroRemote

Image Projection

Basic Procedure

Connect the required external equipment to the projector before operating the following procedures. Details are found in the projector operation manual.

Info

•The language preset at the factory is English. If you want to change the on-screen display to another language, reset the language ac- cording to the procedure on page 37.

1 Plug the power cord into the wall outlet.

•The POWER indicator illuminates up in red, and the projector enters standby mode.

2 Press on the projector or on the GyroRemote.

•The POWER indicator illuminates in green. After the LAMP REPLACEMENT indicator illuminates, the projector is ready to start operation.

Note

•The LAMP REPLACEMENT indica- tor illuminates, indicating the status of the lamp.

Green: The lamp is ready.

Green blinking: The lamp is warming up.

Red: The lamp should be replaced.

•If the power is turned off and immediately switched on again, the LAMP REPLACEMENT indicator may take time to illuminate.

When “Anti-Theft” (see page 102) is set, the keycode input box will appear.

•Enter the keycode. Note

•When entering the keycode, press the buttons previously set on the projector or the GyroRemote.

Info

•When “Anti-Theft” is set, enter the keycode or the input display will not ap- pear. Even when the signal is input, the display will not appear. (See page 102.)

-34

▼Projector indicators

LAMP REPLACEMENT indicator POWER indicator

POWER button	INPUT
	button

Volume buttons

AV MUTE button

INPUT button

POWER button

Volume button

▼Keycode input box

PG-M25X#E#p33_49.p65 34 02.4.29, 3:11 PM