Sharp UX-CD600 Other remote operations, Changing the reception mode, Answering, System, Comments

Remote Operations

Note: You can also call the machine and perform remote operations when the reception mode is set to Auto Attendant, or TEL mode if you call your line 2 number (unless the number of rings is set to 0). In this case, when you call the

machine, press immediately after it answers (press before you hear the fax tone in TEL mode on line 2), and then continue from Step 2 above.

Comments:

♦When a remote command is accepted by the machine, you will hear one beep. If an incorrect command is entered, you will hear four beeps. In the latter case, re-enter the correct command.

♦When entering a command, do not pause longer than 10 seconds between each digit. If you do, you will hear a 4-beep error signal and the digits entered up to that point will be cleared. In this case, re-enter the command from the beginning.

♦If you pause for longer than 10 seconds before entering a command, or make two errors while entering your remote code number, the line will be disconnected. (This prevents unauthorized people from attempting to guess your remote code number.)

Other remote operations

After listening to your messages, you can perform any of the following operations by pressing the appropriate keys on the telephone.

Note: The following commands cannot be entered while messages are being played back. If you do not want to wait until playback ends to enter a

command, first stop playback by pressing and , and then enter the command.

Changing the reception mode

Select a new reception mode by pressing the keys as follows:

Answering	System
3.

♦TAD mode: 8 , 1 , and .

♦ Auto Attendant mode: 8 ,	2 , and	.
♦ TEL mode: 8 , 3 , and	.

Note: If TEL mode is selected, you will only be able to access the machine for remote operation if you call your line 2 number and the number of rings is not set to 0.

79