Silex technology SX-560 manual SET NW Reset, Port Commands Description

Command		Description
SET NW	Sets WPA PSK pass phrase or hex key.
WPAPSK	This value is only used if the authentication mode is WPA-PSK or WPA2-PSK. The
	argument to this command is either a pass phrase of 8 to 63 characters or exactly
	64 hex characters representing the 256 bit PSK value.
	Format:
	SET NW WPAPSK <key>
SH NW DISCONN	Displays the current value of the network disconnection timer
	Sample output:
	Disconnect Timer: 5
SET NW	Sets the period of the network link disconnection watchdog timer. In wireless
DISCONN*	infrastructure mode, this timer monitors the wireless link, and if the unit is not
	connected to an AP for the time specified, the unit is reset.
	SET NW DISCONN nn
	N = 0	watchdog timer is disabled
	1-255	watchdog timer period in minutes
	The factory default value is 5 minutes.
	This timer also controls a receive activity monitor when the wireless network link is
	connected. If no packets are received during the time specified, and the link
	remains up, the unit will reset at the end of the time period.
SET NW RESET*	This command stops, and then resets the wireless network interface. This will
	effectively disassociate the unit from an access point if it is connected. If the unit is
	in wireless infrastructure mode, the unit will then scan and attempt to reconnect to a
	suitable access point, if one is available.
	Format:
	SET NW RESET

*Not implemented in early releases of SX-560 firmware.

Port Commands

Table 35 Port Commands

Note: Examples shown are for Serial Port (S1). To use the commands with Serial Port 2 (S2), substitute the port name S2 instead of S1 in the command

.

Command

Description

SH PORT

Shows port parameters

Sample output:

Port Q-Size Type Attributes

*S1 0 serial 115200 N 8 1 XON/XOFF

Page 78

Silex

Part Number 140-00192-100

Console Commands