Silex technology SX-560 manual Power Configuration Commands, SET Power power-level, SH Power

Command			Description
	19	00080000	GPIO Trigger4: GPIO4 0 to 1
	20	00100000	GPIO Trigger5: GPIO5 0 to 1
	21	00200000	GPIO Trigger6: GPIO6 0 to 1
	22	00400000	GPIO Trigger7: GPIO7 0 to 1
	23	00800000	GPIO Trigger8: GPIO8 0 to 1
	24	01000000	GPIO Trigger9: GPIO1 0 to 1
	25	02000000	GPIO Trigger10: GPIO2 1 to 0
	26	04000000	GPIO Trigger11: GPIO3 1 to 0
	27	08000000	GPIO Trigger12: GPIO4 1 to 0
	28	10000000	GPIO Trigger13: GPIO5 1 to 0
	29	20000000	GPIO Trigger14: GPIO6 1 to 0
	30	40000000	GPIO Trigger15: GPIO7 1 to 0
	31	80000000	GPIO Trigger16: GPIO8 1 to 0

*Not implemented in early releases of SX-560 firmware.

Power Configuration Commands

	Table 41 Power Configuration
Command	Description
SET POWER LEVEL n	Sets the power save mode. High power is for fastest throughput,
	low power is for lowest power consumption.
	SET POWER <power-level>
	Where <power-level> is a numeric value as follows
	0 = High Power (processor always on, never sleeps)
	2 = Low Power
	This is the time in milliseconds to wait before the processor goes
	into power save mode. If no I/O occurs on the network or from the
	attached peripheral within this time period, the processor will go
	into low power mode. The value must be between 0 and 18000000
	(30 minutes). A value of 0 disables processor power saving. The
	default value is 0.
SH POWER	Shows the current power control mode.

Console Commands

Silex

Part Number 140-00192-100

Page 89