Silex technology SX-560 Parameter Command Description, Extended AT Commands Parameter Description

Parameter	Command	Description
Echo control	ATEn	If n=0, commands are not echoed.
		If n=1, subsequent commands will be echoed.
		The default, upon unit reset, is for no echo (ATE0).
Disconnect	ATHn	If n=0, any connection to a remote host is dropped.
		Other value of n is ignored.
Return to data mode	ATOn	Exits command mode and places the serial port in
		the data mode.
		All subsequent data is sent to the network
		application, if connected, until an enter command
		mode sequence is received. Any value of n is
		ignored, if present.
Quiet mode	ATQn	If n = 1, no result codes are returned.
		If n = 0, result codes are returned to the local device.
		0 is the reset default value.
Verbose mode	ATVn	If n = 0 and not in quiet mode, result codes are
		returned in numerical form.
		If n = 1, results are returned as text. 1 is the reset
		default value.

Table 29 Extended AT Commands

Parameter	Command	Description
Console pass through	AT#C<string>	Passes the string to the server configuration console.
		The string can be any valid console command. Refer
		to your server documentation for console commands
		available on your unit.
		Since this command does not follow the normal AT
		command format of <command><number>, it must
		be the last command on the line unless the next
		command is a '#' command. All characters up to the
		end of line or a '# will be considered part of the
		console command.
		If console quiet mode is not is enabled, then the
		response will be the standard console task response.
		Example:
		AT#Cset nw ssid silex#Csave
Console Quiet mode	AT#Qn	If n = 0, a response to a #C command is given.
		If n = 1, the response is not provided. The default
		after reset is 1.

Page 64

Silex

Part Number 140-00192-100

Advanced Configuration