Silex technology SX-560 Modifying TCP/IP Settings, Parameter Description Settings Default Setting

Parameter	Description	Settings	Default Setting
Econn	ECable connection attempt time	1-255 seconds	30 seconds
Ecport	ECable destination TCP port number	Set by user	N/A
Eclport	ECable destination local IP port	Set by user	N/A
	number (required for E-Cable UDP
	mode only)
Ectmmsec	Cable connection time resolution	Enable, Disable	Disable
Ecudp	ECable UDP mode	Enable, Disable	Disable

Restoring Factory Default Settings

The factory default settings can be restored at any time. If you are using the SX-560 Evaluation Daughtercard, hold down the test button for more than five seconds. If you are not using the evaluation board, short GPIO7 on the OEM header to ground (4.7 K-ohm pull-up resistor connected to +3.3VDC) for more than five seconds.

Modifying TCP/IP Settings

You can modify the TCP/IP settings using ExtendView, the web browser interface or the SX-560 module’s internal configuration console.

To modify TCP/IP settings:

1. Using ExtendView, click the TCP/IP tab. The TCP/IP window displays.

Figure 12 TCP/IP Window

Page 46

Silex

Part Number 140-00192-100

Advanced Configuration