Example: For the NSR-100/50

When it does, proceed as follows.

1Click [Shutdown] and turn off the NSR.

2Referring to “Cannot access the hard drive.”, verify whether the NSR hard disks are correctly connected.

3Restart the NSR and verify whether it starts.

4If the same screen as above appears again, insert the supplied NSR Series Recovery CD into the CD and DVD drive, and then turn off the NSR. In this state, restart the NSR, and select “2. Check file System” when the following screen appears.

Checking the file system may take several hours.

5When the check is finished, select “7. Shutdown the system”, and turn off the recorder.

In addition, do not use any menu option other than “2. Check file system” or “7. Shutdown the system”, as the others are for maintenance purposes.

6Restart the NSR and immediately eject the NSR Series Recovery CD. Then verify whether the NSR starts correctly.

The monitor remains blank.

Verify whether the NSR is on.

Verify whether the power cord is correctly connected.

Verify whether the monitor cable is correctly connected. Confirm that the monitor is connected to VGA connector 1.

If you configure the wrong monitor resolution, the “Out of range” message may appear when the monitor resolution is too low compared to the monitor output. Press CTRL+ALT+MINUS SIGN as many times as necessary to lower the resolution of the output video. When the output image resolution reaches the resolution of the monitor, the image appears. Subsequently,

Miscellaneous 182