TANDBERG D14049.04 manual 233

Grey Headline (continued)

Command Reference - xConfiguration

TANDBERG VIDEO COMMUNICATIONS SERVER ADMINISTRATOR GUIDE

Zones LocalZone Traversal H323 H46018 Mode: <On/Off>

Determines whether or not H.323 calls using H460.18 mode for firewall traversal will be allowed. Applies to traversal-enabled endpoints registered directly with the VCS. Default: On

Example: xConfiguration Zones LocalZone Traversal H323 H46018 Mode: On

Zones LocalZone Traversal H323 H46019 Demultiplexing Mode: <On/Off>

Determines whether the VCS will operate in Demultiplexing mode for calls from traversal-enabled endpoints registered directly with it.

On: allows use of the same two ports for all calls.

Off: Each call will use a separate pair of ports for media.

Default: Off

Example: xConfiguration Zones LocalZone Traversal H323 H46019 Demultiplexing Mode: Off

Zones LocalZone Traversal H323 Preference: <Assent/H46018>

If an endpoint that is registered directly with the VCS supports both Assent and H460.18 protocols, this setting determines which the VCS uses.

Default: Assent

Example: xConfiguration Zones LocalZone Traversal H323 Preference: Assent

Zones LocalZone Traversal H323 TCPProbe KeepAliveInterval: <1..65534>

Sets the interval (in seconds) with which a traversal-enabled endpoint registered directly with the VCS will send a TCP probe to the VCS once a call is established, in order to keep the firewall’s NAT bindings open.

Default: 20

Example: xConfiguration Zones LocalZone Traversal H323 TCPProbe KeepAliveInterval: 20

Zones LocalZone Traversal H323 TCPProbe RetryCount: <1..65534>

Sets the number of times traversal-enabled endpoints registered directly with the VCS will attempt to send a TCP probe to the VCS.

Default: 5

Example: xConfiguration Zones LocalZone Traversal H323 TCPProbe RetryCount: 5

Zones LocalZone Traversal H323 TCPProbe RetryInterval: <1..65534>

Sets the frequency (in seconds) with which traversal-enabled endpoints registered directly with the VCS will send a TCP probe to the VCS.

Default: 2

Example: xConfiguration Zones LocalZone Traversal H323 TCPProbe RetryInterval: 2

Zones LocalZone Traversal H323 UDPProbe KeepAliveInterval: <1..65534>

Sets the interval (in seconds) with which a traversal-enabled endpoint registered directly with the VCS will send a UDP probe to the VCS once a call is established, in order to keep the firewall’s NAT bindings open.

Default: 20

Example: xConfiguration Zones LocalZone Traversal H323 UDPProbe KeepAliveInterval: 20

Introduction	Getting Started	Overview and	System	VCS	Zones and	Call	Bandwidth	Firewall	Applications	Maintenance	Appendices
		Status	Configuration	Configuration	Neighbors	Processing	Control	Traversal
D14049.04					233
JULY 2008