
SDLT 600 Product Manual | Chapter 4: Installing Your Tape Drive |
|
|
The Model Number is a character string usually beginning with the letters “TR.”
Model Number: TR
The Serial Number is a character string beginning with the letters “RB.”
Serial Number: RB
3.Check the enclosed SCSI (or Fibre Channel) cable to ensure it is compatible with the SCSI (or Fibre Channel) controller card in the host computer.
4.Check the SCSI (or Fibre Channel) interface on the host computer to ensure that it is compatible with the tape drive. Refer to Table
5.Confirm that your
4.4Configuring and Installing an Internal Tape Drive with SCSI Interface
This section provides information for configuring and installing a tape drive with SCSI interface into a system. See “Configuring and Installing a Tabletop Tape Drive” on page
CAUTION Before you begin, review the safety, ESD, and handling precautions described at the beginning of this chapter to avoid personal injury or damage to equipment.
Configuring the SDLT 600 tape drive system with SCSI interface includes the following tasks:
•Setting the SCSI ID for the tape drive (default = SCSI ID 5)
•Configuring the tape drive to provide TERMPWR
•Setting the configuration jumper (default = wide SCSI enabled).
If you want to change any of the settings, refer to the applicable subsection; otherwise proceed directly to the tape drive’s installation procedures in “Installing the Internal Tape Drive” on page
March 2004 |