Tandberg Data 600 manual Current and Power Requirements

SDLT 600 Product Manual Chapter 3: SDLT 600 Tape Drive Specifications

3.2.3Current and Power Requirements

Table 3-16 on page 3-12lists the current and power requirements for the two versions of the SDLT 600 tape drive system (internal and tabletop) configured with the SCSI interface. Table 3-17 on page 3-13lists the current and power requirements for the internal version of the SDLT 600 tape drive system configured with the Fibre Channel interface. The library version of the SDLT 600 tape drive uses the same amount of power as the internal version with both the SCSI and Fibre Channel interfaces. The tabletop version requires AC power.

The tape drive draws the highest current (and power) during the native write modes. Standby is measured with the tape loaded and tensioned or untensioned, and Idle is measured with power on with no tape loaded. (The power drawn in these two modes is similar enough that they are listed together.)

NOTE: In Table 3-16and Table 3-17, the current and DC power values pertain to the internal tape drive, while the AC power values apply to the tabletop tape drive.

81-81184-02 REV A01 March 2004 3-11