Configuring and Installing an Internal Tape Drive with SCSI Interface | SDLT 600 Product Manual |
|
|
SCSI and Power Connectors
Figure 4-6 on page 4-13 shows the pin orientation for the 68-pin SCSI connector and 4-pin power connector located on the back of the internal tape drive.
The tables list pin assignments for the two possible SCSI connectors: Multi-mode Single-Ended (MSE)/Single Ended (SE) mode in Table 4-3 on page 4-13, and MSE Low Voltage Differential (LVD) mode in Table 4-4 on page 4-15. Pin assignments for the power connector are listed in Table 4-5 on page 4-16.
1.Before connecting the SDLT 600 tape drive to the host computer, be certain the tape drive and computer are powered off.
2.Ensure that your SCSI cables and terminators are
3.If you are connecting several devices to the SCSI bus, connect only the tape drive to the host computer at this time. Confirm that the host computer and tape drive are communicating correctly before adding additional devices.
4.The SCSI bus must be terminated at each end. You may need to terminate this tape drive if one of the following conditions exist:
The SDLT 600 tape drive is the only device connected to the SCSI bus.
The SDLT 600 tape drive is one of several devices connected to the SCSI bus, and it is the last device connected to the SCSI bus.
5.If either condition exists in step 4, attach a “Y” adaptor cable to the tape drive’s SCSI connector; then attach the SCSI cable to one leg of the “Y” and attach the terminator to the other leg. Carefully connect the cables, to avoid bending or damaging the connector pins.
NOTE: You must supply the “Y” adaptor cable to connect both the SCSI connector and the terminator to the tape drive.
6.Attach the power cables to the tape drive. Check the SCSI cable and termination connections and ensure that they are attached correctly and seated firmly.
Optional Loader Connector
The
March 2004 |
